ASTM E2835-11 PDF

Calibration of Light Weight Deflectometers according to ASTM E and TP BF StB Part B, Service and repair. High quality equipments by TERRATEST!. DOI: / E–11 2 For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer Service at [email protected] Scope. This test method applies to measuring plate deflections using a Portable Impulse Plate Load Test device. The method covers the.

Author: Zulkidal Araktilar
Country: Nigeria
Language: English (Spanish)
Genre: Art
Published (Last): 12 March 2005
Pages: 345
PDF File Size: 9.29 Mb
ePub File Size: 14.14 Mb
ISBN: 672-7-18305-236-9
Downloads: 85352
Price: Free* [*Free Regsitration Required]
Uploader: Dohn

And the method was This video shows how easy to move the Zorn Instruments ZFG Light Weight Deflectometer in order to perform testing for deflection and dynamic modulus for Pavetesting Falling Weight Deflectometer to measure the vertical deflection response of a surface to an impulse load, to determine surface material strength or For fine-grained materials, this will help in obtaining a reasonably uniform contact between the load plate and the surface.

Historical Version s – view previous versions of standard. It is the responsibility of the user of this standard to establish f2835-11 safety and health practices and determine the applicability of regulatory limitations prior to use.

Test the compaction quickly, precisely and cost-efficiently on site. Link to Active This link will always route to the current Active version of the standard.


The portable impulse plate load test device ZFG 3. The Static Plate Load Test applies in earthworks and foundation engineering as well as road construction in order to determine load settlement lines and by this The video demonstrates the most commonly used method of the The LWD uses a load cell and geophones with the same accuracy as the Some uses of the data include quality control and quality assurance of compacted layers, and for structural evaluation of load carrying capacity see Note 2 and Guide.

Therefore, care must be taken when analyzing the results because the data obtained by the Portable Impulse Plate Load Test may be obtained under substantially different conditions than when a heavy moving wheel load passes over the pavement surface after construction is complete.

ASTM E Light Weight Deflectometer Calibration | Terratest China

See how fast and easy you’ll measure the compaction of soils in road The volume of the pavement foundation materials affected by the applied load is a function of the magnitude of the load, plate size and rigidity, loading rate, buffer stiffness, and the stiffness and shear strength of the pavement foundation materials. Annimated overview for the Dynatest LWD.

Stanlay Falling Weight Deflectometer The method covers the measurement of deflection of the load plate rather than the deflection of the surface of the pavement or foundation layers see Note 1. The deflection is measured at the center of the top of the load plate see Note 1.


Falling weight deflectometer test fwd Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

The results are used for pavement For the last 40 years, Dynatest has been the frontrunner in structural pavement evaluation with its state of the art FWD Falling Weight Deflectometer. This video demonstrates the moisture-density relations of soils test also called the Proctor Test. Accordingly, the test surface shall be as clean and smooth as possible with loose granules e8235-11 protruding material removed.

International standard ASTM E for Light Weight Deflectometer HMP LFG

For gravel surfaces it is recommended that a thin layer of fine sand be placed over the test point. The values given in parentheses are for information only. Proctor Test, Method A